-
ECT Board Marker Probe BMP-4
- € 392,04 Excl.
- Toevoegen aan winkelwagen
- Electrical Current Rating (Amps): .020 Voltage Rating (VDC): 12 Recommended Duty Cycle: 2 sec. On (min.), 3 sec. Off Materials & Finishes Plunger Material: Carbide Remark to Materials: Receptacle: Stainless Steel Mechanical Test Center (mil): 1,000 Test Center (mm): 25.40 Full Travel (mil): 79 Full Travel (mm): 2.01 Recommended Travel (mil): 50 Recommended Travel (mm): 1.27 Full Marker Travel (mil):…
-
ECT Board Marker Replacement Tip Kit – BMT-4
- € 49,01 Excl.
- Toevoegen aan winkelwagen
- Applications: The BMP Board Marker Probe patented design is for installation on bare board or loaded board test fixtures. When your tester is equipped with the appropriate electronics and software, the BMP scribes a permanent .050” circle on every “passed” PCB or device tested. Boards that fail the test are not marked. The risk of human error is eliminated in…
-
ECT If. pin Zehntel SIP-90-3
- € 0,29 Excl.
- Toevoegen aan winkelwagen
- Test System Interface Probe
-
ECT Plastic Cap PE-2
- € 2,27 Excl.
- Toevoegen aan winkelwagen
- PE-2 Plastic Cap for MSP-3C Switch Probe.
-
ECT Probe MSP-25C
- € 15,06 Excl.
- Toevoegen aan winkelwagen
- Switch probes are used for wire harness contact sensing and component sensing. For applications such as automotive component test where zero defects are allowed, switch probes typically must function without error for tens of thousands of cycles. ECT's switch probes easily meet this standard for reliability.
-
ECT Probe MSP-3C
- € 14,85 Excl.
- Toevoegen aan winkelwagen
- Switch probes are used for wire harness contact sensing and component sensing. For applications such as automotive component test where zero defects are allowed, switch probes typically must function without error for tens of thousands of cycles. ECT's switch probes easily meet this standard for reliability.
-
ECT Probe MSP-3C-1
- € 14,85 Excl.
- Toevoegen aan winkelwagen
- Switch probes are used for wire harness contact sensing and component sensing. For applications such as automotive component test where zero defects are allowed, switch probes typically must function without error for tens of thousands of cycles. ECT's switch probes easily meet this standard for reliability.
-
ECT Probe MSP-5C
- € 13,27 Excl.
- Toevoegen aan winkelwagen
- Switch probes are used for wire harness contact sensing and component sensing. For applications such as automotive component test where zero defects are allowed, switch probes typically must function without error for tens of thousands of cycles. ECT's switch probes easily meet this standard for reliability.
-
ECT Probe SCP-127, DUT style Z, HIB style J
- € 6,95 Excl.
- Toevoegen aan winkelwagen
- Niet zeker welke Probe-Tip (-kop) voor u de meest geschikte is, kijk dan hier! VERENDE TESTPENNEN (Test Probes) Om een geassembleerd printpaneel betrouwbaar te kunnen testen is een 100 % betrouwbare elektrische interface tussen tester en printpaneel een must. Als contactmedium tussen print en tester worden daarom verende testpennen toegepast die in een z.g.n pennenbed, Testfixture of testmal worden gemonteerd.…
